A longtime client picked up this very special car, a Porsche GT3RS 4.0 being gloss black needed serious correction before his desire to wrap the entire car (Sans the decklid & wing). With some lower readings on some areas a few really deep RIDS would have to remain but were significantly reduced in appearance. After a thorough wash and decontamination I measured first the front end where most of the marring and defects were noticeable. Serious care would be needed with these readings. Before correction of the trunk. After a few compounding passes. Working out the defects on the bumper. Continuing on the bumper. Passenger side of the trunklid before. After compounding. Correcting all tight areas for the clearfilm wrap. Finishing down the paint. Now it was time for the wrap, had Kris & Evan come up from So.Cal as they were requested by the client to re-wrap the car as there was a problem and I did not want a conflict of interest on my part of having my film guy do the job(Integrity in all things before profit)as the goal should always be to take care of the client. While I let the film settle, I dialed in the wheels and engine bay. Film job came out very good, client was beyond thrilled and happy to be FINALLY getting his car back. Film that Kris and Evan utilized look so nice I could see the carbon texture under the film on the front end. 4.0 sharing the shop with CGT in for the same treatment, Kris & Evan wrapped that car as well which will be a future write up. 4.0 outside in the sun looking "Tits"!!!. Certified carporn.