2010 Black Camaro SS Clean car already, customer didn't want interior done as it really just needed a wipe down. Car taken to local hand car wash regularly. Tools: PC with 3.5 backing plate GG with 5 inch backing plate Foam Gun Grit Guards GG MF Wash Mitts Leaf Blower Uber 4 inch and 5.5 inch MF pads LC CCS 4 inch and 5.5 white, red and blue Various brushes Sears Drill Adams focus pads Products: Mothers Car Wash Megs All Wheel and Tire Megs APC+ Megs ASD Speedy Prep Towel with Megs LT Megs D300 and 105 Optimum Polish Optimum Finishing polish Wet Glaze 2.0 Megs UPW Adams In and Out Adams Spray Sealant Megs Endurance Tire Gel DG All Metal Polish Towels: Adams MF towels Uber MF towels Process Wheels and tires cleaned with Megs AWT, wells with APC+ various brushes, spot buffed scuffs with drill and Megs 105/205 Engine rinsed, Megs APC+, dried with leaf blower Camaro Rinsed, washed with foam cannon, 1 bucket with grit guard and GG MF mitts Dried with leaf blower Speedy prep and Megs LT for the above surface contamination D300 and 105 mix on MF pad for correcting, Optimum polish on white CCS, Optimum Finishing polish on red CCS, Wets Glaze on red CCS, Megs UPW on blue CCS Engine dressed with Adams In and Out Wheels sealed with Adams spray sealant Tires dressed with Megs Endurance Gel Wells dressed with Megs ASD Exhaust tips cleaned and polished with DG AMP Impressions: Paint was rock hard, swirls were not too hard to remove but RIDS were a PIA and many were in tight areas or edged ares that I worked with the 4 inch pads but too many edges and what not so didn't want to push it. Was using PC on 6 with 4 inch pad and RIDS were still there. Tried M105 straight and Optimum Compound with only a small dent. Customer was very happy, I just wish I could have gotten some of these RIDS out in these areas. Because of the body lines and tight areas I found it difficult, I needed a tiny DA with a 1.5 inch pad..........lol As it arrived After wash and Speedy Prep Notice the curb scuff on the wheel, I was able to polish it out with the drill, Adams Focus pad and Megs 105/205 Same pics with the lights on 50/50's Drivers fender completed All finished at local Cars and Coffee
